Big derrick barge plucks million-pound iron truss off Hood Canal Bridge

SHINE — The largest derrick barge on the West Coast lifted the Hood Canal Bridge’s 512-ton old west truss with little more than a rev of its diesel engine.

“Amazing” was a word uttered often on the mostly sunny day as work continued on removing an old portion of the bridge to replace its eastern half.

It was a surreal scene for onlookers standing on the shore at Shine Tidelands State Park, many who waited all day to see the lift that, by engineering standards, was no big deal considering the DB General’s 700-ton lift capacity.

ADVERTISEMENT
0 seconds of 0 secondsVolume 0%
Press shift question mark to access a list of keyboard shortcuts
00:00
00:00
00:00
 

Once the 280-foot-long, 70-foot-wide and 40-foot-tall truss was in the air — almost a million pounds of steel hanging there like a toy — tugs gently pulled the DB General directly backward. Two other tugs then nudged another barge into perfect alignment under the truss.

The derrick barge slowly lowered the truss onto the barge without a sound.

The DB General “came through big” for the Hood Canal Bridge project, spokesman Joe Irwin said on the www.hoodcanalbridge.com blog Friday.

The bridge was closed May 1 for the project, which is estimated to cost nearly $500 million. It is scheduled to be completed in mid-June at the latest, the state Department of Transportation has said.

On Friday, the lift was originally scheduled at 8 a.m. but hit construction delays, including difficulty torch-cutting through a 3-inch steel plate attaching the truss to the east pontoon and a Navy submarine passing through the more than 1,500-foot bridge gap left by the missing draw span and connecting pontoons.

The truss on the east end of the bridge was removed Wednesday.

Once General Contractors barges the trusses to Tacoma, workers with bridge contractor Kiewit General will dismantle them for recycling.

The new trusses will connect the floating pontoons to the concrete approach roadways that have foundations in Kitsap and Jefferson counties.

New trusses

The new steel trusses weigh about 1.6 million pounds each — more than four Boeing 787 Dreamliner airliners, state Department of Transportation officials said.

They will be nearly 100 feet longer and 30 feet wider than the old trusses to match the widened bridge roads atop the pontoons, allowing Transportation to increase capacity on the bridge from two to four lanes.

The trusses are designed like hinges to rise and fall 16.5 feet with the tidal ebb and flow, maintaining the connection between the stationary roadway and floating bridge.

The trusses, the only ones of their kind in the state, are primarily made of structural bridge steel members that range from 20-inches to 42-inches in diameter.

________

Port Townsend-Jefferson County Editor Jeff Chew can be reached at 360-385-2335 or at jeff.chew@ peninsuladailynews.com.

More in News

Fred Lundahl, a pilot from Whidbey Island, prepares to fuel up his 1968 Cessna Aerobat, named Scarlett, at the Jefferson County International Airport in Port Townsend. Lundahl was picking up his plane Wednesday from Tailspin Tommy’s Aircraft Repair facility located at the airport. (Steve Mullensky/for Peninsula Daily News)
Fueling up

Fred Lundahl, a pilot from Whidbey Island, prepares to fuel up his… Continue reading

After hours pet clinic set for Peninsula

Opening June 6 at Sequim location

Five to be honored with community service awards

Ceremony set Thursday at Port Angeles Senior Community Center

PASD planning for expanding needs

Special education, homelessness, new facilities under discussion

Clallam County Sheriff’s Office Animal Control Deputy Ed Bauck
Clallam Sheriff appoints animal control deputy

Position was vacant since end of 2024

Highway 104 road work to start week

Maintenance crews will repair road surfaces on state Highway… Continue reading

Supreme Court says no to recall reconsider

Sequim man found liable for legal fees

Chimacum Ridge seeks board members

Members to write policy, balance values, chair says

Fire destroys shop east of Port Angeles

A fire on Hickory Street east of Port Angeles… Continue reading

Jefferson Transit Authority to expand Kingston Express route

Jefferson Transit Authority has announced expanded service on its… Continue reading

From left to right, Northwest School of Wooden Boatbuilding students Krystol Pasecznyk and Scott McNair sand a Prothero Sloop with Sean Koomen, the school’s boat building program director. Koomen said the sanding would take one person a few days. He said the plan is to have 12 people sand it together, which will take a few hours. (Elijah Sussman/Peninsula Daily News)
Wooden boatbuilding school building ‘Twin Boats’

Students using traditional and cold-moulding construction techniques